Search found 165 matches

brought a angle measurer thing from lazer ended up not using it as it was shite and used traditional rightangle and a bit method Wink

hmm will it hurt doing it ? i mean technically we is at 107 already having done up to the running engine stage, yesterday i got the zorst gasket and zorst manifold with the whole engine in on somefin ...

i use speaker wire to pull new cable through as it usually snaps when im in a car park somewhere

i leave it off gear box end get it all in ratchet then push to its upper much position for slack the ...

really !! god damn it ive had to put the whole engnie back together so i could run it for a bit then slacken them of then retighten 19 more stages!!

this is not what it says in the hayns but frmo a ...

all reno prices and all with 20 % off chris you cant ask for more than that though in retro spec the 80 pound for the head bolt set was a bit much

also i havent found a local factor that could prod ...

i replaced the heater matrix on my 19 and had the rad out on the lawn flushing it with a hose pipe and then flushed the systwem with hose pipe andworked a treat no orange for the next 2 years but damn ...

lol whats chris on holiday lol Razz

ive got 5 bolts left over and i dont know which ones go in the 3 holes ive got left to fill !!!

megane F7R 710

get a nice clean set from your local motor factors, even halfords will do discs quite cheap, they also doing trade discount soon from there

Its right hurting my back doin these bolts all most as difficult as sump plugs......(wait for it)

soo am i right in assuming following the haynes book of lies on this is spot on ? as ive only angl ...

also forgot new thermostat Wink

at 12 quid i got that while i was at it, but that wasnt the problem but you is defo right the thermostat housing crumbles in your hand even at 63k but i still used my old ...

addie my friend thats more money Razz

but im gunna go with orange stain down theback Wink

yeah i did that chriss wd 40 only ran through past 3 valves but when i took it to get skimmed today they said they coould reseat all the valves and skimm it for 90 notes i thought thats not to bad whe ...

oh dude id love to but thus far this is already taking too long and im not gunna take the bottom end apart as well i think i shall cross that road if and when it happens

its me only transport well ...

gotta be carefull no shite falls in to the head when you do it

alright chris need some advice

few day ago cambelt snapped on me F7R laydened megane it also was having to be topped up everyother day with a complete header tank of water

i got thehead off toda ...

cheers chet didnt know if they arrived off the net till god knows when

lol hey rusty its been a while, yeah good memories hehe

800 quid now me dads shouting "get it off me drive" etc

wheels sold

got left 1 x alternator 1x powersteering pump 1x starter moter 1x head 1x broken block

loads of manifolds inlet zorst etc and rocker covers

everything 10 pound each

lol i too was at college there hehe ill text ya the address

40 done chet though me internets on and off so msn me when im on

they a bit scuffed and tyres are close if not on the minimum wear mark but the spares got a good tyre from new on it hehe all 5 whee ...