Search found 40 matches

They are the height adjustable ones.

Im sure i have the correct parts, apparently its a common coilover problem.
I have bought some washers to see if that sorts it

Right my coilovers sound lovely and quiet Rolling Eyes

when going over bumps etc.
So i got some new top mounts, and took apart the coilover.
After looking at the coilover the top metal plate of the coil ...

Cool. will have a look at that, where abouts is the earth situated?

Will have an gander around there.
Wont be a sensor playing up as its 2 lights for different functions.
Will try to find the culprit lol.

All of the oil guages work fine which is odd.
Apparently it only happened when the master cylinder was replaced.
So a damaged wire near there would be a likely suspect.

On my Williams, when i start the car, the oil and water warning light stay on, what would cause these to stay on?
I know the oil and water is fine.

Thanks.

Sold.

Pics:

http://homepage.ntlworld.com/peterj.jones/My%20Clio/Latest%20Shots%2020.01.06/Cool%20Front%20On%20(1).jpg

http://homepage.ntlworld.com/peterj.jones/My%20Clio/Latest%20Shots%2020.01.06/Cool ...

Right after a new purchase i no longer need my valver.
I have done alot of work since i bought it, and would say that it is in good condition now.

Since i bought it i have had the arches and back ...

Couple of pics i got of mine:

http://chrisharrison.smugmug.com/photos/66073933-M.jpg

http://chrisharrison.smugmug.com/photos/65904656-M.jpg

It was only Â£15 Wink

Was a good day out,
Didnt know yours had anything done to the inlet, it sounded good though!

Shame the airfield is being sold.
Looking forward to seeing the pictures and vids people have.

you can just liner it.

Cool, how much on average does that cost?

Im getting a new brake line made up, but the person who is making it wants to know what sort of union it is. ie thread pitch and type etc.
All i know is its a 11mm union

Thanks.

Those trees you cant trust them they just jump out at you Wink

Does the F7R have wet or dry liners, and can you change the insert or would it have to be bored out?
I know of a bottom end which has been worn due to sand getting in so has lost compression, so figu ...

Got them done in the end, was a combination of 2 G clamps to get the ones in the middle on and the wishbone ones was done with the jack and a leverage bar to get it into position.

Cheers.

Cool
The best way of getting things tensioned up so they can be done up would be a G-clamp? any tips or other suitable tools for the job?

Thanks.

Ah ok.
Is it normal for the arb not to line up with the holes on the wishbones by a good amount, as the rubbers sit at a angle and then you get the tension from that?

I have a set of anti roll bar rubbers for my 16v and as im putting on a new subframe to my car and have it all off, whats the easiest way to put the arb rubbers on?
I have the wishbones on, and had a ...