 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
simonds1
Site Subscriber
Joined: 29 Jan 2005
Posts: 1108
|
| Posted:
Mon May 02, 2005 3:53 pm |
|
Is the exhaust on a ph1 and ph2 R19 the same? I'm assuming yes? And also, is the exhaust for a 3dr hatch the same as a 5dr hatch? Cuz the cars are the same length? I've seen an exhaust on ebay which is off a ph1 3dr hatch, and just wondering if it'd fit my ph2 5dr hatch |
|
|
|
|
Neal
Forum Moderator
Joined: 18 Feb 2004
Posts: 7432
|
| Posted:
Mon May 02, 2005 10:35 pm |
|
yes, yes and yes as long as it has a cat (not one piece straight through front section) if you want it to go through at MOT time. If its got a wide tailpipe like the standard ph1 job youll obviously need to chop your phase 2 bumper about a bit. |
|
|
|
|
simonds1
Site Subscriber
Joined: 29 Jan 2005
Posts: 1108
|
| Posted:
Tue May 03, 2005 2:48 am |
|
Cheers Neal. Oh yeah, speakin of choppin bumpers about a bit........did you need to cut your bumper for your magnex at all? Oh no wait, you had a scorpion on before that didn't you? I'm guessing you had to cut it for the scorpion? |
|
|
|
|
Neal
Forum Moderator
Joined: 18 Feb 2004
Posts: 7432
|
| Posted:
Tue May 03, 2005 9:24 am |
|
yeah the other bumper was cut for the scorpion when i got the car... badly i might add. I tidied it up as much as i could, but it never looked good.
When i bought the car that i took the magnex off, i used the rear bumper too, unmolested as it is. The magnex fits perfectly in the standard little cutout thing in the hatch bumper no modification required, fits perfectly in there, almost like it was designed to fit  Looks ace. |
|
|
|
|
simonds1
Site Subscriber
Joined: 29 Jan 2005
Posts: 1108
|
| Posted:
Tue May 03, 2005 10:37 am |
|
Legend  |
|
|
|
|
|
|
| |