 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
Lunner
Level 6 User
Joined: 18 May 2005
Posts: 162
|
| Posted:
Wed May 18, 2005 12:52 pm |
|
I have a 1.8 8v RSi engine, F3P, and i've been led to believe that the F3R block from the 2.0 8v lagune will fit straight on to the head and gearbox.
Can anyone confirm/deny this?
Also i presume that if i get a complete block and head i will need a lagune loom/bodge mine up to it, and it goes wihtout saying a new ECU |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Wed May 18, 2005 1:19 pm |
|
|
|
|
Lunner
Level 6 User
Joined: 18 May 2005
Posts: 162
|
| Posted:
Thu May 19, 2005 11:22 am |
|
Cheers 
Any ideas on the capatability of the looms if i just drop the complete lump in? |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Fri May 20, 2005 12:27 am |
|
not entirely 100% sure on this.
The bottom end will deffo bolt straight on though, the same gaskets are used btw.
The injectors on the 2 litre lump are 2 noles efforts pressing against a rubber washer, dunno if its different on the older rsi's.
Also the laguna loom is in 2 bits, the top section and lower section whilst on the clios and 19's its 1 loom.
The heads on the 2l are particularly crap, I am gonna port the lagunas a bit before I stick the head back on today.tomorrow. |
|
|
|
|
|
|
| |