 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
huwwatkins
Site Subscriber
Joined: 10 Jun 2004
Posts: 2317
|
| Posted:
Wed Dec 07, 2005 11:42 am |
|
Seems the 1.4 has had a bit of an accident with its blades, apparantly they got a bit 'over excited' and went off the side of the screen and bit...sister reckons the arms might be a bit bent, but not enough so they wouldnt go back to resting position.
Now though, they only move slightly when operated and no further.
Thoughts? Burnt motor? |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Thu Dec 08, 2005 1:34 am |
|
the spindles probably worn. Happens a lot.
Take the wiper arms off and operate the wipers the spindles should go back and forth. Its a poor design the spindles corrode inside their bearings.
Anyway its the splines that normally go.
If the spindles work fine with no arms on then you need to put the arms back on in the right position and tighten them up properly. |
|
|
|
|
huwwatkins
Site Subscriber
Joined: 10 Jun 2004
Posts: 2317
|
| Posted:
Thu Dec 08, 2005 6:20 am |
|
Fixed, turned out to be a loose bolt  |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Thu Dec 08, 2005 6:28 am |
|
|
|
|
schakal
Spammer
Joined: 27 Jul 2004
Posts: 5717
|
| Posted:
Fri Dec 09, 2005 10:49 am |
|
damm ,you done it again  |
|
|
|
|
|
|
| |