Retro-Renault Archive Forum Index  
SEARCH THE ARCHIVE FORUMS  •  Log in
Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website. 
 Head bolts
Author Message
huwwatkins
Site Subscriber

Joined: 10 Jun 2004
Posts: 2317

Posted: Mon Mar 14, 2005 5:25 pm

Looking in haynes it sais that in the last stage or tightening up have to do the bolts up to a torque of 25Nm. The wrench im looking at getting only does 30 and up, does it matter that its 5Nm out or does it have to be exact?
BenR
Level 5 User

Joined: 18 Jun 2004
Posts: 114

Posted: Mon Mar 14, 2005 5:36 pm

its pretty vital, and you still have the angle torqing to do.
Chris H
Forum Moderator

Joined: 02 Mar 2004
Posts: 19978

Posted: Tue Mar 15, 2005 1:09 am

yes go buy a 3/8's torque wrench. The 1/2 inch drives only read from 28 upwards normally.
huwwatkins
Site Subscriber

Joined: 10 Jun 2004
Posts: 2317

Posted: Tue Mar 15, 2005 7:03 am

found a draper one for 29.99 in motorworld, 3/8 , should do the job, just need a 3/8 > 1/2 convertor for me torx bit
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Tue Mar 15, 2005 4:19 pm

convertor is a couple quids from halfords
JB
Mr Quoter-vator

Joined: 16 Feb 2004
Posts: 7405

Posted: Wed Mar 16, 2005 2:10 am

my 1/2 incher starts at 28, but i just counted a few down below the 28 mark...did the job fine....plus the 1/2" wrench is much more useful to have thana 3/8"
Display posts from previous:      


 Jump to:   




SPIDER ARCHIVE
Powered by phpBB © 2001, 2002 phpBB Group :: FI Theme :: All times are GMT - 7 Hours