One for compulsive comparative paranoids - collection

Level 1 User Joined: 25 Jan 2006 Posts: 39

It's early in the morning now and tomorrow when I wake up I'll probably laugh at myself for writing this but since we're in these early morning hours, I'll just get on with it...

So, without further due, I would like to collect every possible F7P data in one thread, something that will be useful for people rebulding, tuning or just fiddling with the numbers...

And a note...if you guys remember my car and my thread, you could read there that I had a F7P conversion in plan for my GTE...and that's exactly what's going to be done soon, since a friend of mine accidently found a engine from R19 complete with wiring for 100 Ł, and I'll rebuild it, share the pics here of course and have a good ride hopefully in a month or two...

Back to the mega spec thread...here it goes, and since I'm not the F7P owner yet, I'll let the experienced folks write in the numbers...

::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::

BLOCK

Bore/stroke :
Rod lenght :
Main bearing # :
Main bearing diameter :
Main bearing width :
Rod bearing # :
Rod bearing diameter :
Rod bearing width :
Cam bearing # :
Cam bearing diameter :
Cam bearing width :
Piston rings (compression - oil) # :
Flywheel weight :

::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::

HEAD

Inlet valves # :
Inlet ports # :
Inlet valve size :
Inlet Port lenght :
Inlet Port width :
Inlet Port height :
Inlet Port shape :
Exhaust valves # :
Exhaust ports # :
Exhaust valve size :
Exhaust Port lenght :
Exhaust Port width :
Exhaust Port height :
Exhaust Port shape :

::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::

INLET MANIFOLD

Runner diameter (at head) :
Runner lenght :
CFM rating :

::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::

EXHAUST MANIFOLD

Header diameter :
Header lenght :
Collector lenght :

::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::

CAMS

Centerline, degrees at TDC :
Duration at 1.25 mm :
Open at 1.25 mm (before TDC) :
Close at 1.25 mm (after TDC) :
Max lobe lift :
Intake duration at 200' :
Lobe separation :

There... Shocked

Site Subscriber Joined: 28 Jan 2005 Posts: 3547

i can give you weights of the con rods/pistons. The bore is 82.00mm(standard) and most other info is in either JB's or my engine rebuild prog reports.