Retro-Renault Archive Forum Index  
SEARCH THE ARCHIVE FORUMS  •  Log in
Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website. 
 My luck with Renault
Author Message
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Thu Jun 02, 2005 2:44 pm

Hello, havve scrapped the R21.

Need help with the Espace Chris. What would make it idle too fast when hot?

I noticed a leak / crack in the exhaust manifold and welded it up. Since then the thing will not idle less than 1500 RPM.

Any ideas?
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Thu Jun 02, 2005 2:45 pm

probably messed with the lambda sensor you did ,that causes idleing problems when hot me thinks
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Thu Jun 02, 2005 2:46 pm

Tell me where the Lambda sensor is and I tell you if I messed with it Very Happy
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Thu Jun 02, 2005 2:54 pm

Right found it, under the manifold. Replace this then?

I had heard that fast idle = too much air intake.
huwwatkins
Site Subscriber

Joined: 10 Jun 2004
Posts: 2317

Posted: Thu Jun 02, 2005 2:54 pm

In the exhaust, just before the cat
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Thu Jun 02, 2005 2:55 pm

i believe its at the same place on the escapes , shall be a screwy bit with a cable sticking out ,and its on the cat pipe ,between the cat and the flange
Neal
Forum Moderator

Joined: 18 Feb 2004
Posts: 7432

Posted: Thu Jun 02, 2005 2:59 pm

my god, lambda, what are you talking about? Rolling Eyes
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Thu Jun 02, 2005 3:15 pm

so what do you reckon it is proffessor neil ?
Dan
Site Subscriber

Joined: 28 Jan 2005
Posts: 3547

Posted: Thu Jun 02, 2005 11:55 pm

ICV - Idle control valve
CTS - coolant temp sensor
Chris H
Forum Moderator

Joined: 02 Mar 2004
Posts: 19978

Posted: Fri Jun 03, 2005 12:34 am

wot (I mean what really) dan said.

But make sure the throttle plate is closing properly. give it a clean out.

But I would say no coolant temp reference.

Unplug the sender see if that drops the idle.
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Fri Jun 03, 2005 1:20 pm

Now you mention it Chris, the temp seems to be 5-10% higher. Dont tell me head gasket, my head would pop.

A confession I have to make is I swapped the air box from the R21 to the Espace before I scrapped it as the Espace has had a head gasket go in the past and the coolant had rusted the wing nut and bolt on the top.

Also I swapped over the aluminium Renault Injection housing on top of the butterfly, well bcos it was easier than cleaning it.

Does this help?

I havent had a chance to do anything Today as her indoors had to go shopping for decorating stuff. Done 100 miles in it Today and it seems to idle faster the warmer it gets.

Thanks to the poters who replied, you lot are gr8.

Guys if you know where the ICV and CTS are it would be appreciated.
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Fri Jun 03, 2005 1:39 pm

this is a CTS on a renault 19 ,dont know if its the same on the escape
Image
you shall find this screwed on to the engine head


and here is the ICV on a 19 16v again

Image

hope these help
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Fri Jun 03, 2005 1:44 pm

Fanbloodytastic, they are not disimilar.

I have stripped the 21 so have all the bit to swap and change, gr8 info.

Which one 1st or trial and error??
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Fri Jun 03, 2005 2:18 pm

i would not suggest to swap the CTS ,just buy a new one for 8-9quid

about the ICV ,it usually just needs cleaning with some carb cleaner or wd40 to get the crap out of the turning bit .
gtd
Newbie

Joined: 18 Dec 2004
Posts: 10

Posted: Fri Jun 03, 2005 3:42 pm

the CTS on my espace is on the lefthand side of engine near the thermostat housing. got my new CTS from gsf for 17.50p
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Fri Jun 03, 2005 4:17 pm

Sorry guys but I am not gonna pod out £17.50 for a new until I have tried the one from the R21. I value your opinion but I have a spare.

A CTS is normally a liquid filled device that expands when warm, bit like a thermometer, come variable mechanical rheostat. If the one in situ is not working then the best option is put on the spare. If it has the same problem then surely it is something else.
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Fri Jun 03, 2005 4:24 pm

why not just disconnect the plug from the CTS and see if it makes any difference first before the swap ??
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Fri Jun 03, 2005 4:35 pm

Can do, when they were called TSU's, temp sender units they went into the coolant /water jacket. I do not see the problem of using the spare. I know they now have four connecters instead of one but why not use the one off the R21?

You guys know more than I do but please explain.
schakal
Spammer

Joined: 27 Jul 2004
Posts: 5717

Posted: Fri Jun 03, 2005 5:02 pm

as long as its the same CTS you can use the one of the 21 of course but the thing with the CTS is they do get knackard due to running inside hot water all the time , even before swapping the CTS s you might even take the one out and give it a good clean with some sanding paper .

temperature sender unit/sensor is another thing though and got nothing to do with the CTS , tsu sends the coolant temperature to your temp gauge on the instrument panel while CTS sends the info to your ECU Wink
Chris H
Forum Moderator

Joined: 02 Mar 2004
Posts: 19978

Posted: Sat Jun 04, 2005 2:30 am

gsf it costs 11 quid, I buy them often!

Anyway there are tech articles on the TB and ICV cleaning in the knowledge base!

when you swapped over the injection cap did you make sure it was flat and no air leaks?

Although the fact the speed raises as it heats up basically tells me your not getting any sort of idle control from temp change, the speed goes up because the oil thins but the fuelign stays the same.

CTS
Smirn
Level 1 User

Joined: 03 May 2005
Posts: 26

Posted: Tue Jun 07, 2005 5:56 pm

Sorted, cheers fellahs. It was indeed CTS.

Didnt buy a new one though, bit naughty but still worked.

Thanx again Very Happy
Display posts from previous:      


 Jump to:   




SPIDER ARCHIVE
Powered by phpBB © 2001, 2002 phpBB Group :: FI Theme :: All times are GMT - 7 Hours