 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
mixpioneer
Site Subscriber
Joined: 29 Dec 2004
Posts: 395
|
| Posted:
Wed Nov 23, 2005 9:24 am |
|
Whats the best way to remove and refit valve guides?
Do i have to make sure they go back where they came from when refitting?
Do i have to make sure the valves go back with the guides and ports they came out of?
Any info much appreciated!
Tom |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Wed Nov 23, 2005 11:26 am |
|
the right tools and you need to get the seat machined as well once they are in. |
|
|
|
|
mixpioneer
Site Subscriber
Joined: 29 Dec 2004
Posts: 395
|
| Posted:
Thu Nov 24, 2005 10:01 am |
|
And the right tools are??
So the valves can't just be lapped in i take it. Or will the difference in the valve guide possition (although very slight) be too much??
Any good articles or guides on cylinder head rebuilds?? |
|
|
|
|
Lunner
Level 6 User
Joined: 18 May 2005
Posts: 162
|
| Posted:
Fri Nov 25, 2005 11:03 am |
|
valve spring compressor, or do you already ahve the valves out? |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Fri Nov 25, 2005 11:33 am |
|
mandrel drifts a large oven etc. |
|
|
|
|
mixpioneer
Site Subscriber
Joined: 29 Dec 2004
Posts: 395
|
| Posted:
Sat Nov 26, 2005 3:48 am |
|
right, i'll get that idea out my head then lol |
|
|
|
|
|
|
| |