Various 19/clio bits for sale -updated!

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

I will add more stuff as I come across it.

I am open to offers on everything. MAKE ME AN OFFER ON ANYTHING, WORST i CAN SAY IS NO!

pics of items on request!

449 BLUE PH1 STUFF

front o/s wing - few scratches
front n/s wing - few scratched mild surface rust and a ding
rear bumper hatch
n/s front door for 3 door
16V bonnet - some rust
3 door hatch side skirt
plastic under headlight trim
bulkhead removable panel where the ignition module bolts to - Chets having this

Glass

3 door hatch rear o/s pop open window

Exterior trim

front arch liner n/s - small crack around a fixing point, not an issue though
front arch liner o/s
handbrake heatshield
top 16V heatshield
n/s ABS scuttle cover
n/s black unpainted manual mirror - with glass
n/s black unpainted manual mirror - no glass cracked casing
o/s black unpaited manual mirror - glass damaged adjuster needs to be swapped over, easy job
Bonnet stay
various clips, grommets and trims
door handles
bonnet stay
master cyl heatshield
heatshield for manifold where the starter cable runs down

Interior trim

hatch black boot bottle holder on the n/s
16V gear gaiter - some splits
uncut grey hatch parcel shelf
16V 4/5 door seat side trims - 2 sets of them
seat runners - loads of them
misc dash trim eg under the heater panel, under the steering column etc
misc clips, bungs and covers
door handles
window winders
ph1 19 16V seats front and rear good condition
black 16V gear lever surround ashtray thingy
n/s seal where the door trim meets the window on the 3dr
seat adjuster, the black bar you pull to move the seat back and forth x 7
4/5 door drivers height adj seat frame
4/5 door pass seat subframe x 2
rear damper top covers x 5

Electrical

heater fan x 5 - suits clios as well as all 19's
washer bottle and motors
grey door switch - no nipple bit though
non central locking tailgate loom
non 16V front lighting loom x2
non 16V non injection front to rear loom
16V alt condition unknown
1.4 energy alt - worked when removed from car
front wiper mechanism and motor x 2
wiper arms - both sides a few sets
16V dash loom and meta system cat 2 immob
1.4 base model dash loom, no rev counter etc!
washer stalk not trip comp
heated rear window switch
ciggy lighter socket thingy
front wiper mech x2
rear wiper hatch mech
rear wiper arm
front wiper arms x 3 pairs
battery tray thingy, the black plastic with the drain the battery sits on
starter motors x 3
16V alt - unknown quantity, ideal for exchange etc i suppose

Braking, drivetrain and suspension

238mm used discs - about 5k on them good condition
non 16V o/s driveshaft - needs inner gaiter
non 16V n/s driveshaft
clio o/s 1.4 driveshaft - new still in renault box
large n/s hub
large o/s hub x 2 - broken bolts in hub flange
small n/s hub
JB1 gearbox - about 100k on it, good condition
Clutch cable - used but fine
rear dampers x4 - used but mot passable
front dampers - passable
19 16V power steering pump x 2
19 16V ps fluid oil cooler
rear engine mount bracket
front lower gearbox bracket - clio cup racer mod
19 manual rack steering column

Fuel system

injection filler neck
carb filler neck
1.8 SPI 3 bolt throttle body SOLD
GTT anti perc fans and ducting x 2

Ignition

HT leads - various
coils x 2

Exhaust

F7P Exhaust manifold x 2 - no studs
F7P Downpipe x2 - no heatshields
E6J/E7J/K4M exhaust manifold - studs removed no cracks - SOLD

Induction

19 16V air box feed pipe
clio 1.4/19 1.4 air box feed pipe
E6J airbox

Cooling

radiator hoses various 19 and clio

Engine

F7P bottom end - needs rebuilt
E6J bottom end - 110 k, i only drove it once, but it started fine

ICE

Alpine 6x9's
Pioneer 6x9's

Come on folks what doesn't get sold/taken gets binned

Site Subscriber Joined: 23 Jan 2005 Posts: 502

Have you got two inside rear mirror plastic bits. They fit on the inside of the doors, covering the three nuts that hold the door mirrors on.

As mine still have the hole for the manuel mirrors

Retroholic Joined: 12 Feb 2004 Posts: 5685

"bulkhead removable panel where the ignition module bolts to"

I'll have that

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

I am not sure 1916S I think I used my last 2 spares ont he red car. I will have a look though.

Chet ok, I'll swap ye for some stuff.

Level 9 User Joined: 09 Mar 2005 Posts: 453

dont supoose you have a black parcel shelf do you chris?

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

yes but i am unsure if I have 2 or not.

If I have 2 then yes is the answer to that question.

i will check tonight as that sort of stuff is at my flat

Level 9 User Joined: 09 Mar 2005 Posts: 453

excellent..aslong as its got no speaker cut outs and is standard..i will have it off you..if you've got one.

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

just checked mate, I don't have a spare black one, sorry.

i have a grey one if you want it though.

Level 9 User Joined: 09 Mar 2005 Posts: 453

not to worry chris..i will pass on the grey one..gota be the black one mate.

thanks anyway.

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

come on folks I have to get rid and I need money, must be someone wanting something!

Level 3 User Joined: 22 Mar 2006 Posts: 72

I need a pad retaining pin for the rear caliper of a clio, with the circlip, also need a rubber gaitor to go over rear piston, again on clio

Have you any of these to sell??

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

should have the plate, pin, the gaiter I might have but chances are it may be slightly torn/damaged.

Level 3 User Joined: 22 Mar 2006 Posts: 72

Sound, throw us a price for the pad pin and payment details in a pm then Chris..

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

I'll go look for them first matey

but will do!

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

_G_ activate your pm's matey!

Level 3 User Joined: 22 Mar 2006 Posts: 72

Done

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

R1916S";p="92825 wrote:

Have you got two inside rear mirror plastic bits. They fit on the inside of the doors, covering the three nuts that hold the door mirrors on.

As mine still have the hole for the manuel mirrors

just found the passenger (or in your case drivers) door one, I will keep hunting for the other, but they are yours matey.

Site Subscriber Joined: 23 Jan 2005 Posts: 502

Cool PM me for shipping ect. if you find the right side one.

Level 8 User Joined: 07 Sep 2005 Posts: 315

Chris, how much do you want for 'F7P bottom end - needs rebuilt' ? Is it the one that seized? Have you a full F7P you would like to sell?

Forum Moderator Joined: 02 Mar 2004 Posts: 19978

R1916S never found the other side, but you can have that one if you want it matey.

Yes its the one that siezes after 10 minutes of running, leave it 20 and it can be driven another 10. Its probably a big end issue.

No full engines sold my last one to doc.

The bottom end is a tin sumper if you want it make me an offer for it.

Level 3 User Joined: 22 Mar 2006 Posts: 72

Check your email chris